ATS Maximus MCJ2000 Series, Справочное руководство

Страница: 50 / 214

2-18 Maximus Reference Manual MANU-MAXIMUS-02
Revision-02
Connections Chapter 2: Installation
Hand-Held CCD Scanner
If you have an optional ATS hand-held CCD scanner (Part Number 9000/39), plug its cable into
the Wand Socket on the Maximus Main Board as shown in
Figure 2-21 .
Figure 2-21 Connecting a Hand-Held CCD Scanner
WiFi External Antenna
The optional WiFi module comes with two antenna. One ships connected to the module and
mounted to the outside of the Maximus outer case. A second antenna, equipped with a 5-
meter cable (Part Number 17-7005-00), provides flexibility for locations with poor WiFi
reception. Use the following procedure to install the 5-meter antenna:
1. Disconnect the factory installed antenna from the WiFi module.
2. Route the 5-meter antenna into the Maximus terminal and connect it to the
WiFi module as shown in
Figure 2-22 .
3. Move the antenna to the strongest signal strength and secure it by removing the
protective paper on adhesive back on the antenna then attaching the antenna
to a wall or other stationary structure.
Figure 2-22 Installing the 5-Meter Cable Antenna