ATS Maximus MCJ2000 Series, Справочное руководство

Страница: 105 / 214

Chapter 3: Monochrome Terminals Test Mode
MANU-MAXIMUS-02 Maximus Reference Manual 3-51
Revision-02
Serial Test: Printer
This test requires specific loopback “jumper” and is typically only performed by an ATS service
technician. It is noted here for reference purposes.
1. Install the “jumper” in the serial /printer port on the terminal.
2. In the Test Mode menu, press the clear key until the Serial Test: Printer
option appears.
3. Press the enter key to start the test. The terminal reports that the test is in
progress If desired, you can interrupt and stop the test by pressing the clear key.
When the test is complete the terminal displays the result.
4. When you are finished, press the clear key to exit the serial printer test and
display the Serial Test: Printer prompt. You may now remove the jumper from
the terminal.
LED Test
The LED test cycles each LED on and off so you can confirm they are working. Use the
following procedure to run the LED test:
1. In the Test Mode menu, press the clear key until the LED Test option appears.
Test Mode
Serial Test: Printer
Serial Test: Printer
Test in progress
Test Mode
LED Test