Atrix Rapid Red Stick Vacuum ACSV-1, Руководство пользователя

Страница: 12 / 14

TROUBLESHOOTING
The vacuum will not power on.

This may be caused by a dead battery. This can occur if the vacuum has been
used or stored for an extended period of time. Connect the vacuum to the
charger and allow for a full charging cycle to complete.
The vacuum stopped suddenly:

This will occur if the safety/ thermal cut-out device has been activated.
This device is designed to prevent your vacuum from overheating.
Ensure the vacuum is turned off, disconnect and remove any blockage
from all accessories and extension tube.

Empty the dust container and clean or replace the filter.

Replace/recharge battery
The suction of the vacuum has reduced:

Turn the vacuum off. Disconnect the floor head, extension tube and any
accessories. Check for and remove any blockages from the dustbin filter, air
duct, extension tube floor head and accessories.
Motorized floor head is not rotating:

This tends to occur when there are too many fibers wrapped around the brush
roll restricting movement. Consult the maintenance section of this manual for
instructions on how to appropriately clean the brush roll.
The charging indicator light does not flash up:

There may be a bad battery.

There may be a bad charger.

There may be a bad outlet.
The run time of the vacuum is less than it used to be:

Ensure the battery has completed a full charging cycle. An insufficient charging
cycle will result in reduced run time.

There may be reduced energy discharge in the battery. This is normal and
gradually occurs in all batteries over time.
SPECIFICATIONS