- 7 -
6. Close the vacuum cleaner again.
7. Always replace the HEPA filter bag after sweeping up large quantities of fine material such as fine sand,
cement, flour, etc.
***Atrix Part # for a 10 pack of replacement HEPA filter bags: AHC-2***
Cleaning the motor filter
1. The motor filter can be found in the dust bag container. It protects the motor
from dust and should be cleaned at least twice a year when it is dirty, or if
suction force is reduced.
2. Pull the filter holder up out of the vacuum cleaner.
3. Open the filter holder, and remove the filter. Rinse the filter in warm water,
and allow it to dry completely. Do not use a hair dryer or similar to dry the
filter.
4. Return the filter to the holder, and replace the filter holder in the vacuum cleaner.
IMPORTANT! Never use the vacuum cleaner without a motor filter.
Cleaning the exhaust air filter
The exhaust air filter cleans the air a final time before it leaves the vacuum cleaner. You can clean the exhaust
air filter as follows:
1. Switch off the vacuum cleaner and disconnect the plug from the outlet. To do this, always pull on the plug
and not on the cord.
2. Open the exhaust air grill (this is at the rear and top of vacuum cleaner).
3. The exhaust air filter is visible when the grill has been opened.
4. Rinse the filter under cold running water and allow dry.
5. Put the exhaust air filter back into place (or replace with a new one) and place in the grill.
6. Close the exhaust air filter grill.
Transport and Storage
1. You can lift and carry the vacuum cleaner using the carrying handle. Never pull or lift the vacuum cleaner
by the cord.
2. Before putting the vacuum away, rewind the cord. Turn vacuum off, unplug, and press the cord rewind
button until the cord is fully rewound.
3. To save space, the vacuum can be stored upright on its end cover. The telescopic wand can be hung on
the vacuum cleaner by inserting the parking fixture into the vertical parking holder.
MotorFilter
