Atop SE59XX-SDK, Руководство пользователя, Страница: 26 / 75

SE59XX-SDK
Software development Kit
User Manual
V1.2
[ 0.378364] jffs2: version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
[ 0.378550] msgmni has been set to 997
[ 0.379395] io scheduler noop registered
[ 0.379410] io scheduler deadline registered
[ 0.379431] io scheduler cfq registered (default)
[ 0.381146] pinctrl-single 44e10800.pinmux: 142 pins at pa f9e10800 size 568
[ 0.382600] Serial: 8250/16550 driver, 48 ports, IRQ sharing enabled
[ 0.400065] omap_uart 44e09000.serial: no wakeirq for uart0
[ 0.400264] 44e09000.serial: ttyO0 at MMIO 0x44e09000 (irq = 88, base_baud = 3000000) is a OMAP UART0
[ 1.028894] console [ttyO0] enabled
[ 1.033403] omap_uart 48022000.serial: no wakeirq for uart0
[ 1.039392] 48022000.serial: ttyO1 at MMIO 0x48022000 (irq = 89, base_baud = 3000000) is a OMAP UART1
[ 1.050604] omap_rng 48310000.rng: OMAP Random Number Generator ver. 20
[ 1.068218] brd: module loaded
[ 1.076954] loop: module loaded
[ 1.080664] (hci_tty): inside hci_tty_init
[ 1.085470] (hci_tty): allocated 251, 0
[ 1.091197] Atop update device initialize success.
[ 1.096857] 2000020.atop_relay:
[ 1.100095] Register atop_relay0 success.
[ 1.105516] 200000e.atop_cpld:
[ 1.108659] Register atop_cpld_ver0 success.
[ 1.115365] mtdoops: mtd device (mtddev=name/number) must be supplied
[ 1.125434] usbcore: registered new interface driver cdc_ether
[ 1.131779] usbcore: registered new interface driver smsc95xx
[ 1.137863] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[ 1.144735] ehci-omap: OMAP-EHCI Host Controller driver
[ 1.150487] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
[ 1.157004] ohci-platform: OHCI generic platform driver
[ 1.164668] 47401300.usb-phy supply vcc not found, using dummy regulator
[ 1.174193] musb-hdrc musb-hdrc.0.auto: Failed to request rx1.
[ 1.180400] musb-hdrc musb-hdrc.0.auto: musb_init_controller failed with status -517
[ 1.188587] platform musb-hdrc.0.auto: Driver musb-hdrc requests probe deferral
[ 1.196932] 47401b00.usb-phy supply vcc not found, using dummy regulator
[ 1.206284] musb-hdrc musb-hdrc.1.auto: Failed to request rx1.
[ 1.212478] musb-hdrc musb-hdrc.1.auto: musb_init_controller failed with status -517
[ 1.220652] platform musb-hdrc.1.auto: Driver musb-hdrc requests probe deferral
[ 1.242648] input: beeper.7 as /devices/beeper.7/input/input0
[ 1.250121] omap_rtc 44e3e000.rtc: rtc core: registered 44e3e000.rtc as rtc0
[ 1.258078] i2c /dev entries driver
[ 1.264330] oprofile: using arm/armv7
[ 1.268471] TCP: cubic registered
[ 1.271973] Initializing XFRM netlink socket
[ 1.276527] NET: Registered protocol family 10
[ 1.282075] sit: IPv6 over IPv4 tunneling driver
[ 1.289180] NET: Registered protocol family 17
[ 1.293908] NET: Registered protocol family 15
[ 1.298623] 8021q: 802.1Q VLAN Support v1.8
[ 1.303099] Key type dns_resolver registered
[ 1.308461] ondemand governor failed, too long transition latency of HW, fallback to performance governor
[ 1.319330] PM: bootloader does not support rtc-only!
[ 1.324662] ThumbEE CPU extension supported.
[ 1.329187] Registering SWP/SWPB emulation handler
[ 1.335887] lis3_reg: disabling
[ 1.339233] regulator-dummy: disabling
[ 1.343584] omap-gpmc 50000000.gpmc: GPMC revision 6.0
[ 1.349016] gpmc_mem_init: disabling cs 0 mapped at 0x0-0x1000000
[ 1.357218] spansion,s29gl256p11t: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x000001 Chip ID 0x002201
[ 1.368582] Amd/Fujitsu Extended Query Table at 0x0040
[ 1.374002] Amd/Fujitsu Extended Query version 1.3.
[ 1.379317] Advanced Sector Protection (PPB Locking) supported
[ 1.385627] number of CFI chips: 1
[ 1.389506] 6 ofpart partitions found on MTD device spansion,s29gl256p11t
[ 1.396663] Creating 6 MTD partitions on "spansion,s29gl256p11t":
[ 1.403078] 0x000000000000-0x000000080000 : "u-boot"
[ 1.409937] 0x000000080000-0x0000000a0000 : "u-boot env"