MB52XX Modbus Gateway
User Manual
Configuration
and
Setup
After finishing configuring the
Slave ID Settings
, click the
Save Configuration
button to save all changes that have
been made
.
A
Save Successfully
message will show up, then the web browser will be redirected back to the
Slave
ID Settings
page
.
Below the
Slave ID Settings
box, there is a list of mapping entries as shown in
Figure 4.17 in which each line will
summarize an
Entry No
.
, a Modbus
Protocol
, a
Source
, a Slave ID Setting
Mode
, and the
Slave ID Range
(
Virtual <
-
> Real
)
.
Check the box in front of each entry to select that entry
.
Then, click
Remove
button to remove that particular
entry from the
Slave ID Map
.
To remove all entries, check on the box in front of the header line and click
Remove
button
.
Figure 4.17 Slave ID Map Web Page with Slave ID Setting in in Offset Mode
