3. BEFORE FIRST USE
You have bought the Aton Handy diving light, which despite its small size offers high performance, new
intuitive control technology and advanced safety features.
Please read the enclosed manual carefully and contact us at
in case of doubt.
The battery is not supplied in a fully charged state. It must be charged before first use.
4. CHARGING
Do not charge in high ambient temperatures, in direct sunlight, in damp or frosty conditions.
Charge in a suitable, dry, covered place and on a non-flammable material.
Charge only with the supplied charger.
Disconnect the lamp after charging.
The supplied charger can be connected to the electrical network with voltage ~ 110V / 220V. Never
connect the charger to a power supply that is not of the correct voltage.
Never use the charger if the wire insulation is obviously damaged. This may cause electric shock
or damage to the lamp.
Here's how:
1. Connect the charger connector to the charging connector located in the battery case.
2. Plug the charger into a wall outlet. Mains ~ 110 / 220V
a) if the LED on the charger is red, the battery is charging,
b) if the LED on the charger is green, the battery is charged.
3. Disconnect the charger from the wall outlet, then the connector from the battery case.
BATTERY MAINTENANCE:
- never leave the battery in a discharged state after use, especially in a cold environment. It would lose its
capacity. We recommend that you recharge the battery as soon as possible, regardless of whether it is
partially discharged. Neglect of maintenance is not covered by the warranty.
5. PLACING THE LAMP INTO OPERATION
Lightly grease the two O-rings on the battery case and the surfaces in the head of the lamp on which they
are moving.
Then insert the battery case into the head of the lamp. Tighten the two parts together so that there is no
visible gap between them by turning the battery case in the clockwise direction (when viewed in the
lighting direction). This makes the lamp ready for operation.
After tightening, there must be no visible gap between the two parts. Once this condition is met, it is
undesirable and unnecessary to use excess force to tighten tightly again - re-opening could be
problematic
.
Содержание HANDY
Страница 1: ...Aton HANDY OPERATING INSTRUCTIONS...