Before Using the laser engraving, please read this safety guide carefully, it mentions situations that require special attention and includes
warnings of unsafe practices that can cause damage to your property or even endanger your personal safety.
1. The product belongs to Class 4 laser products, the laser system itself must meet the requirements of IEC 60825-1 latest version, otherwise
the product is prohibited to be used.
2. Our laser engraver have a protective housing which, when in place, prevents human access to laser radiation.
3. If a protective housing is equipped with an access panel which provides "walk-in" access then:
a)means shall be provided so that any person inside the protective housing can prevent activation of a laser hazard that is equivalent to Class 3B
or Class 4.
b
）
There is a warning device is situated so as to provide adequate warning of emission of laser radiation equivalent to Class 3R in the
wavelength range below 400 nm and above 700 nm, or of laser radiation equivalent to Class 3B or Class 4 to any person who might be within
the protective housing.
c) Where “walk-in” access during operation is intended or reasonably foreseeable, emission of laser radiation that is equivalent to Class 3B or
Class 4 while someone is present inside the protective housing of a Class 1, Class 2, or Class 3R product shall be prevented by engineering
means.
NOTE Methods to prevent human access to radiation when persons are inside the protective housing can include pressure sensitive floor mats,
infrared detectors, etc.
Part 1
：
Security Statment Before Installation
