7
INPUTS, OUTPUTS & BUTTONS
14. INPUT SENSITIVITY BUTTON -
This button sets the input level for use with active or passive pickups.
With the button out the unit is set for lower output passive pickups. With the button in the unit is set
for higher output active pickups.
15. INPUT JACK
- Plug the instrument in to this 1/4” jack.
16. DIRECT OUT
- This 1/4” output jack is hardwired to the input jack and sends your dry instrument
signal out. This output might be used to send the dry instrument signal to a bass amp or direct box.
17. OUTPUT
- This 1/4” output jack would normally be used for sending the output signal to a power
amp and speakers for on-stage monitoring.
18. XLR OUTPUT
- This XLR output jack would normally be used for sending the output signal to a P.A.
mixer for live use or an audio interface for recording.
19. GROUND LIFT
- Pushing this button in will lift the ground. This can be helpful in eliminating 50Hz or
60Hz ground hum noise.
20. HEADPHONE OUTPUT
- This 1/8” (3.5mm) output allows you to connect headphones to the bass
box for silent practicing.
21. AUX INPUT
- This input mixes directly to the headphone output jack. This allows you to connect a
music player to the bass box and play along with music. You must use the volume control of the music
player to adjust the volume of the music.
22. DC POWER JACK
– 9 volt, 200mA minimum, center negative polarity, 2 .1mm coax plug.
23. USB CONNECTOR
– This is a USB MINI B connector for connecting to a host PC. Allows for editing
and uploading custom user cabinet impulse data and firmware via host editing software application.
24. BYPASS FOOT SWITCH
- The BASS BOX is toggled between enabled and bypassed with the Bypass
foot switch.The right LED will turn on YELLOW to let you know the unit is active. If this LED briefly
flashes red, this is normal and indicates that your compressor mode is entering a compression /
limiting mode. If this LED blinks red in rapid succession for a few seconds, this indicates that you are
overloading the input. You can remedy this by trying to lower the output level knob until the clipping
goes away. Otherwise, you may need to activate the input pad by pressing in the Input Sensitivity
button next to the input jack. This will lower the input level to the Bass Box.
14
16
17
18
19
20
21
22
23
24
15