IMPORTANT INFORMATION
• This product must only be installed by a licensed
electrician.
• Before commencing installation turn off and isolate the
electrical supply.
• No user serviceable / replaceable parts inside.
• Do not attempt to service other parts of the unit as this
will void the warranty.
Microwave sensor 12 m - recessed mount - white
INSTruction MANUAL
AT4100/MW/WHT
Microwave SENSOR
Mounting
Mounting options
Recessed mount
Installation height
1.5 - 3.5 m
Cut out
ø 63 mm
Dimensions
ø 75 / 72 mm
57
ø 75
15
N
L’
L
N
IN~
L
Load
Installation
Remove the product from the box and inspect it for any damage. If you
believe the product to be damaged or otherwise unsound, do not install
the product. Please return it to the place of purchase for replacement.
If the product is satisfactory, proceed with the installation:
1. Remove the screw from the transparent cover on the base to
access the terminal block, as per fig 1.
2. Feed the mains cable through the strain relief and connect the
mains cable into the terminal block, as per the wiring diagram
below.
3. Reattach the transparent cover and fix screw in original position.
4. Pull the spring clips up as per fig 2, insert sensor into the desired
position and release the spring clips, ensuring that the sensor is
secure and flush up against the ceiling.
1
2
transparent cover
strain relief
spring clips
Wiring diagram
Product Specification
Sensors
Microwave, ambient light
Supply voltage
220 V ~ 50 Hz
Output load
1200W incandescent
600W inductive
300W LED
Operating temperature
-20 to 40°C
Field of view
360°
Detection range
2 - 12 m (adjustable)
Detection motion speed
0.6 - 1.5 m/s
Time delay
Min. 10 sec ± 3 sec
Max. 12 min ± 1min
Ambient light
< 3 - 2000 lux (adjustable)
Ingress protection
IP20
Material
PC UV stabilised
Detection pattern
Detection Zone
Range ø
Height
Max
12 m
2.7 m
1
2
3
1
2
3
3
1
4
5
6
2