Atom 506AV, Руководство владельца оператора

Страница: 8 / 20

8
STARTING & STOPPING INSTRUCTIONS
(CONTINUED)
1. The Atom Edger is very easy and simple to use. For
some people, it may take a few edgings to become
use to it.
2. Thoroughly inspect the area where the edger is to
be used and remove all stones, sticks wires and
other foreign objects.
3. Adjust blade height (Fig. 15). With a new blade, try
the second hole closest to operator.
5. PULL THE STARTER ROPE BRISKLY until the
engine starts. Gradually move the choke lever to
the open position. Allow engine to warm-up until it
runs smoothly.
6. Throttle trigger (engine accelerator control) is
operated by pushing down interlock with thumb and
pulling on trigger (Fig. 12C).
TO AVOID PERSONAL
INJURY, NEVER CARRY
THE EDGER WHILE THE ENGINE IS RUNNING.
Stay clear of the rotating blade. Stop the engine
prior to making adjustments and cleaning.
!
WARNING
EDGING INSTRUCTIONS
7. HOT OR WARM START: (Engine has already been
started and warmed up). Switch ignition “ON”.
Make sure you have a firm footing with one foot on
the cross brace. Pull starter until motor runs, allow
to warm-up.
NOTE: A built in automatic centrifugal clutch
disengages the blade from rotating at engine idle
speed. The clutch engages the blade when the
engine speed is increased.
8. FLOODED ENGINE: (Engine will not start). If smoke
or fuel comes from exhaust and engine will not start.
a) Check that ignition switch is “ON”, CHOKE
LEVER is on RUN position.
b) Pull starter rope up to 10 times to clear engine
of fuel so it can start.
c) If engine has excessive fuel that cannot be
cleared by (a) & (b) above, remove spark plug from
engine and from spark plug terminal, crank engine
to clear excess fuel, wipe and dry spark plug of all
fuel, re-install spark plug terminal, and restart as
above.
9. To stop engine push ignition switch down on top of
throttle trigger away from operator (Fig 10).
AFTER FINISHING WORK
Storing for a short period: Keep the unit in a dry place
until you need it again. Do not store where open flame
or electrical machinery is operating.
Storing for a long period: Drain the fuel tank and run
engine until carburettor is dry.
4. With both arms extended
downwards, as in Fig. 16, hold
both handle grips firmly. With
the engine running, pull the
throttle trigger full on. Engine
must run at full speed.