PAGE 3
SAFETY PRECAUTIONS
(CONTINUED)
SAFE WORKING INSTRUCTIONS
AND IMPORTANT ADJUSTMENTS
Never operate your machine if it is damaged, improperly
adjusted or not completely and securely assembled. At correct
idle speed, the blade should not turn. Do not use the Atom
Edger with incorrect idle speed (refer Adjusting the Carburettor
instructions on page 6).
SAFE MAINTENANCE, REPAIR
AND STORING
Use only original Atom replacement parts for maintenance and
repair. Use of parts manufactured by others will void warranty
and/or may cause serious or fatal injury.
Always stop the engine, make sure
that the blade is stopped before
adjusting blade height, doing any maintenance or repair work,
or cleaning the unit or blade.
!
WarnIng
Follow the maintenance instructions in the appropriate section of
this manual. Any repairs should be carried out by an authorised
service dealer or person with suitable servicing experience.
A worn or damaged muffler is a fire
hazard and may cause loss of hearing.
Check to see that the muffler is in good condition. The lawn edger
must not be operated if the muffler is not functioning properly, is
damaged, or has been removed. In order to reduce the risk of
fire, do not modify or remove any part of the muffler and ensure
it is not worn or broken.
!
WarnIng
Remember that the risk of forest or grass fires is greater in hot
weather.
Never touch a hot muffler as burns
will result.
!
WarnIng
Store Atom Edger in a dry, high or blocked location and out of
reach of children.
Never store the machine with gasoline
inside a building where fumes may
reach an open flame or spark (e.g. gas or oil-fired heater
appliance, electric motor, etc.)
!
WarnIng
Before storing for a longer period, always empty the fuel tank.
Start and operate your unit outdoors
and in a ventilated area.
!
WarnIng
Keep the space behind and beside the engine clear at all times to
allow for the escape of hot and toxic exhaust fumes.
Operate your machine under good visability and daylight
conditions only. Work carefully.
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects or other reproductive harm.
!
WarnIng
Do not touch hot engine during and
immediately after use as you may
burn yourself.
!
WarnIng
Check fuel filler cap for leaks at regular intervals. Use the
specified spark plug and make sure it and the ignition lead are
always in good condition.
ASSEMBLING DELUXE EDGER
1. Fit bolt #1 through captive plate #2 (Note: arrow to front), through handle tube
#3, main casing body, then handle tube #4 on other side. Screw on handle
knob #5 loosely.
2. Fit cross brace #6 to both handle tubes #3 & #4 using screws #7 and nuts #8.
3. Rest throttle cable and switch wire #9 on top of cross brace #6 and fit RH
throttle handle #10 onto end of handle tube #4. Use screw #7 & nut #8 to
secure handle. Repeat for left handle #11.
4. Clip throttle cable and switch wire #9 into slot on top
of cross brace (as shown in Fig. 7). Clip cable holder #13.
Tighten handle knob #5.
5. When assembled unit will look
like Fig. 8.
6. Adjust edger height with
handle adjuster #12.
Try hole 3 for first
edging attempt.
FIG 8
FIG 7
8
4
7
12
5
10
9
6
7
8
8
11
7
7
3
2
1
13
440.450_Deluxe Edger_manual_16.9.11.indd 3
17/10/11 1:02 PM
Содержание 440
Страница 7: ......
