11
III. CONNECTION TO COLD WATER LINE
ATTENTION: ensure that the filter is connected to a cold water line (t
max
is 38
о
C).
Connection to a hot water line will damage the filter.
1. Close the valve that shuts cold water off. Open the cold
water tap on a basin mixer to depressurize the line. If water
still flows from the tap even after valve closing, you have to
close the main valve in the house or apartment.
2. The system is connected to the water supply line via the
water supply unit.
The filter set may include the combined water supply unit –
T-tap. In this case ref. clause 2.4.
2.1. Assemble the water supply unit by connecting the ball
valve with the T-piece as shown in
Fig. 8
. Using PFTE tape,
screw the T-piece in the tap. Be especially careful while
connecting the tap - excessive force will damage its thread.
Use only a small spanner or wrench. Do not use other
materials to seal connections.
2.2. Loosen the cap nut and disconnect the flexible line from
the basin mixer.
2.3. If necessary, replace the gasket of the cap nut.
2.4. Install the assembled unit in the flexible line from the
basin mixer, as shown in
Fig. 9
. Use a spanner or a wrench.
2.5. Connect the red tube to the filter (ref. Table on page 12)
and to the ball valve.
2.6. Close the tap at the inlet of the filtration unit and open the
ball valve. Check connections for leaks.
Fig. 8
Fig. 9
