ATN Zebra 16, Руководство оператора и по безопасности

Страница: 44 / 80

OPERATOR AND SAFETY MANUAL
44
1NO0035UK-05
Zebra 16
DANGER
DO NOT ACTIVATE THE EMERGENCY
STOP TO CUT THE ALARM AND
CONTINUE WORKING.
IF POSSIBLE, LOWER THE PLATFORM
BACK
AND STOP USING THE
MACHINE.
-
If the alarm does not stop, tighten the load spring by about ¼ turn and
lift the platform again by about 5cm, repeat this procedure until the
alarm stops.
8. Release the platform, the alarm sounds (if not, repeat step 6).
- There may be a slight delay before the platform overload alarm
responds.
9. Lift the platform again by about 5cm, the alarm shall stop (if not, repeat
step 7).
10. During the alarm activation, test all the machine functions from the
ground and platform controls. All functions should should be disabled
except for Arm 3.
11. Remove the test weight from the platform.
12. The alarm must be off, test all the machine functions from the ground
and platform controls. All functions should operate.
5.4. SYSTEM FAULT
The system fault light comes on when the
control system detects an anomaly on one of
the components or an operating fault.
Depending on the importance of the fault for the
safe use of the machine, the system authorises
the operation of certain command in degraded
mode or completely disables the use of the
machine.
The exact nature of the fault is indicated on the
control module screen: See Section 8
The machine's operation is re-established when
the fault disappears or after the emergency stop is recycled (depending on the nature of the
fault).
In all cases, the machine's use must be interrupted until the fault is corrected. After repair, a full
check on the operation of the machine and the safety mechanisms must be carried out by a
qualified person before the machine is returned into service.
If a fault occurs when the platform is raised and is occupied by personnel, appropriate
measures must be taken to rescue the platform's occupants.
5.5. MOVEMENT ALARMS
A movement alarm may sound:
- During drive movements
- During lifting structure movements
- During drive and lifting structure movements
See § 8.3.1
– Safety settings.