4
automatIc Shut-off SyStEm
The automatic shut-off system turn the power off when the device is upright on the flip-up headset.
When device is returned into the working position the system turn the power on again.
450 mw InfRa-RED IllumInatoR
( o P t I o n al)
The 450 mW IR Illuminator works on a separate
battery from the main unit. To install the battery
unscrew cap and insert battery in the same direc-
tion as depicted by the diagram on the IR. To in-
stall the 450mW IR Illuminator to the scope screw
the adapter into the thread on the scope. Install IR
to the rail of adapter and screw fixator.
The IR illuminator control buttons are located on
its side. To switch the Digital IR illuminator on/off
press “+” and “-” buttons simultaneously. When
the IR illuminator is switched on you can see the
green LED lit. By pushing the buttons “
+
” and “
-
”
you may adjust the IR brightness.
The IR beam is focusable to change the field of
coverage. To change the beam width slightly turn the IR lens.
You could change the IR control panel fitting your needs. The screw-tool included into the set should
be used for weakening the fixing screw located on the IR. Rotate the IR placing it in the most conven-
ient position. Tighten the screw with the screw-tool to fix the new position.
For installation IR450 use adapter with Picatinny rail. Mount the adapt
3X lEnSES
( o P t I o n al)
The additional 3X Afocal Lenses a for PS-23 transform it to 3X binocular.
To install 3X Afocal Lenses screw it on the front lens of PS-23.
camERa aDaPtER
( o P t I o n al)
To use your PS-23 with a 35mm camera or camcorder you will need the following:
1) If you plan to use a camcorder then your camcorder must have a MACRO feature. Most modern
camcorders today have a MACRO feature built-in.
2) If you plan to use a 35mm camera, you will need a MACRO lens. If you don’t have one, we advise
that you contact your local camera store.
3) You may or may not need a STEP-UP or STEP-DOWN ring in order to adapt the camera adapter
to your lens.
NOTE:
The camera adapter comes with 37mm and 52mm threads. If you
need other sizes your local camera store should be able to help.
• Remove the rubber eyecup from the PS-23
• Screw the camera adapter onto the front of the lens on your Video camera’s
lens or your 35mm camera’s lens.
• Loosen the three set screws on the camera adapter.
• Place the camera adapter over the PS-23’s eyepiece.
• Tighten the three set screws to fit snugly to the PS-23’s eyepiece
Battery
Housing
Fixation
Screw
IR Elevation
IR Windage
IR Focusing
IR Brightness Adjustment
Adapter