5
1) Determine your daytime scope
objective tube diameter
(
ex-
ternal - not diameter of the glass lens!
)
with a millimeter ruler
(with a trammel for more accurate results) as shown at the pic-
ture.
2) Select from the Table 1 the Insert size
closest (larger)
to the
value measured (Insert size is also specified at an Insert body).
Do the selection in Insert group that corresponds to the
same
Scope Mounting System (for example, Scope Mounting System
#2).
3) The Scope Mounting System you need is the one that corre-
sponds to Insert size selected at the Table 1.
For example, if your scope objective tube diameter is equal to 46
mm then you should select Insert with size of 46,7 mm and cor-
responding Scope Mounting Systems #3 from the Table 1.
Platform Ring
IR Illuminator can be mounted not only onto
PS-22 with Picatinny Rail Adapter but also onto a
daytime scope using optional Platform Ring. To
perform this do the following:
1) Unscrew the two screws set (A) from the Plat-
form Ring.
2) Place the top and lower parts of the Platform
Ring around your daytime scope tube (B), as
shown on the picture.
3) Tighten hard the two screws set (A).
Daytime Scope Light Suppressor
There is a rubber Daytime Scope Light Suppressor (DSLS). The DSLS slides over the eyepiece of
your daytime scope.
The DSLS was designed to achieve several missions:
1) Prevent back glow from the device that could give away position
2) Prevent surrounding light from interfering with image on eyepiece
The DSLS can be adjusted for the eye relief of your scope by cutting the rubber at the desired distance.
OPERATION
Place the PS-22 before objective of daytime scope.
Make sure the power switch is at the OFF-position.
Install the battery into the housing with the polarity order shown at the de-
vices body. The battery is 3 volt lithium battery (CR123A).
To turn the device on, draw and rotate the operation switch to the ON-po-
sition. The greenish-lit screen of the image tube (when looking through the
eyepiece) means that the image tube is powered on.
Do not turn the unit on during daytime without the protective lens cap/ day-
light filter on.
A
B
A
