10
pREpARINg FoR opERATIoN
Daytime Sniper Scope :
• Install the battery for illuminated reticle into its housing.
• Adjust the magnification by rotating the magnification ring near eyepiece.
• Observe the scene and adjust the eyepiece for optimal clarity. Get focus by rotating the
focusing ring of the eyepiece.
• Turn on the reticle illumination if you need.
• Adjust the reticle brightness by rotating the 10-position rheostat.
Night Vision weapon Sight :
• Install the batteries into their housing at night-vision eyepiece and IR illuminator respec
-
tively with the polarity order as shown at the device body.
• Turn on the night-vision eye-piece with the switch located on its body.
• Observe the scene and adjust the eyepiece for optimal clarity. Get focus by rotating the
focusing ring of the eyepiece.
• Turn on the IR illuminator .
• Adjust IR brightness.
• Focus the illuminator by rotating its lens.
bATTERIES
The batteries (included) are coin style 3 volt lithium batteries (CR2032) for Electronic
Reticle and two 3 volt lithium batteries (CR123A) for Night Vision Eyepiece and IR Illumi-
nator.
VERY ImpoRTANT!
Your Day/Night System comes with a patented technology that puts the lit reticle
of the riflescope into an infrared mode which helps prevent the tube from being
burnt out. However, even in this mode if the brightness of the reticle is turned up
too high you can run the risk of burning the reticle pattern into your night vision
light intensifier tube screen.
This damage is not covered by the warranty!
When setting the reticle brightness of your scope to Night Vision Mode please
set the brightness at the lowest visible setting comfortable for you. This will
prolong the life of the Light Intensifier Tube. We suggest you to turn the reticle
brightness to the (1) position and then increase it slowly until you see the reticle
clearly. Do not over-increase the reticle brightness.
