Atmel AVR ICE 200, Руководство пользователя

Страница: 25 / 40

Using the ICE 200
AVR ICE 200 User Guide 4-9
6. AVR Studio can now be started. However, do not open any files before connect-
ing power supply to the ICE 200. If the ICE 200 is not powered then AVR Studio
cannot detect the emulator and therefore enters simulation mode.
7. The ICE 200 has no power switch. Just connect the power supply cable shipped
with the ICE 200 to a +9V to +12V DC or a 9V AC power supply, and then con-
nect the power cable to the ICE 200 (see Figure 4-11). A battery eliminator is a
good alternative to the laboratory power supply shown on the figure.
Figure 4-11. Connecting Power Supply to ICE 200
8. Enable the target power supply. The red LED will now be lit, telling that power is
present, but no connection to the host PC has been established.
The hardware is now ready for use. Use the checklist below to ensure that the setup
was done correctly, and then proceed to the next section: Configuration.
4.6.1 Checklist 1.
o
Turn-off power on all units.
2.
o
Insert personality adapter.
3.
o
Pins on adapter agree with pins on target.
4.
o
Mount pod.
5.
o
Mount FPC (first time only, do not disassemble).
6.
o
Connect RS232C cable.
7.
o
Turn-on power on all units.