Atmel AVR ATICE10, Руководство пользователя

Страница: 27 / 35

AVR
®
ATICE10 User Guide 5-1
Section 5
Hardware Description
5.1 Front Panel
Figure 5-1. ICE Unit Front Panel
5.1.1 Status LEDs The ICE unit front panel is shown in Figure 5-1. Two LEDs on the front panel indicate
the status of the emulator. After power-up, the red LED will be lit, indicating that the
power supply is OK and the green LED is turned on after a few seconds when initializa-
tion and self-test are finished indicating that the emulator is ready for use.
5.1.2 Logic Analyzer
Connectors The Logic Analyzer connectors are outputs for external Logic Analyzer. Pinout and
description on how to use these connectors can be found in Section 3.8.
5.1.3 AUX Connector The AUX connector in an I/O-port for Trigger signals. Pinout and description on how to
use this connector can be found in Section 3.7.
5.1.4 POD Connector Both ATtiny15POD and the AT90ADCPOD should be connected to this connector.
Table 2-1 on page 3 shows which pod to use.
5.2 Back Panel
Figure 5-2. ICE Unit Back Panel
5.2.1 Serial Number Every ICE10 unit has a unique serial number. If technical support is needed, this num-
ber should be provided with a detailed description of the problem. The serial allows
technical support to track what firmware the specific ICE10 contains.
5.2.2 Serial Port RS232 C The ICE unit is connected to an RS-232 port on the host PC with the supplied RS-232
cable. All serial communication is done at 19200 bps using no parity, 8 data bits and 1
stop bit (N81).
5.2.3 Parallel Port The Parallel port is not in use on the ICE10.
5.2.4 AVR Prog.
Connector The AVR Prog. connector is not in use on the ICE10.