Installation Guide
AT-VSP-800-BL and AT-VSP-800-WH
3
24V
DC
/ 0.5A
LAN
/ PoE
802.3af
compliant
D
esigned
in
the
USA
M
anufactured
in
Taiwan
Installation and Set Up
1
Connect the Ethernet cable into the back of the unit.
a
If the Ethernet cable is connected to a non PoE switch, use a PoE injector using 802.3at
(purchased separately).
2
Secure the unit in either the wall or optional stand, as explained in the mounting instructions.
3
The Velocity logo will display during the booting process and will go directly into setup.
Press
CONTINUE
to start the setup process.
NOTE:
Installation of the Velocity Touch Panel can only be done after the AT-VGW-
HW-3/10/20 has been set up. View the AT-VGW-HW-3/10/20 Installation Guide and
Velocity Manual for instructions.
Initial Setup
CONTINUE
You will be guided through the setup process
in the next few screens.
4
When the unit displays the IP information, press
CONTINUE
.
a
If the touch panel does not display an IP, select the Set Static IP slider.
b
Assign the unit a static IP. Ensure there are no other devices on the network with the
same IP to avoid connection issues.
