AT-OMNI-238
10
Installation
1. Connect an Ethernet cable from the network switch to one of the Ethernet ports.
2. Connect included DC 24V power supply into the unit and the wall/power management switcher.
3. *Optional* Connect an Ethernet cable from the remaining Ethernet port to one of the Ethernet ports of another AT-
OMNI-238 for cascading without the need to connect each individual OMNI 238 directly to a network switch.
4. Connect captive screw connectors from the outputs to audio players/distribution devices.
Audio Connector
Connect to an audio DSP, amplifier, or other audio distribution or player devices. Either balanced or unbalanced
connections may be used.
1. Use wire strippers to remove a portion of the cable jacket.
2.
Remove at least 3/16” (5 mm) from the insulation of each wire.
3.
Insert the wires into the correct terminal on the included Phoenix connector, as shown below.
4. Tighten the screws to secure the wires. Do not use high-torque devices as this may damage the screws and/or
connector block.
Connection Instructions
LINE/MIC IN
-
+
LINE/MIC IN
-
+
Negative
-
+
Positive
+
Positive
Gr
ound
Gr
ound
Balanced
Unbalanced
