Atlona AT-OPUS-RX, Руководство по установке

Страница: 3 / 8

3
Installation Guide
AT-OPUS-RX
RS-232
A 3-pin captive screw connector has been
included for RS-232.
Pin out will be determined by the RS-232 cable
and connect as RX (receive), TX (transmit) and
(Ground).
A 5-pin captive screw connector for IR control has been included. The first three terminals are IR
inputs to be used with an IR receiver (AT-IR-CS-RX purchased separately through atlona.com),
the last two terminals are for IR outputs to be used with the included IR emitter.
IR OUT is connected by a ground and
signal wire. Use with the included IR
emitter to pass signals to the display
from a control system.
IR IN is connected by a power,
signal, and ground wire. Use with
IR receivers to pass IR signals
back to the transmitter.
IR
IR IN IR OUT
GND S
GND RX TX GND RX TX
The AT-OPUS-RX includes two mounting brackets and four mounting screws, which can be used
to attach the units to any flat surface.
1. Remove the top 2 case screws on the side of the unit.
2. Align the mounting brackets to the side of the units.
3. Use the previously removed case screws to secure the mounting bracket to the enclosure.
4. Repeat the steps for the other side of the unit.
Mounting Instructions
S
P
S
PoE
RX
TX
HDM
I OU
T
IR IN
IR OU
T
RS-2
32
AUD
IO IN
ETH
ERN
ET
LINK
PoE
DEB
UG
HDB
aseT
IN
AT-
OPU
S-RX
PW
R
LINK
RECEIVER
OPUS
TM
Case screws
GND S P