AT-OME-SW32
17
webGUI
8. Select Display to adjust display control settings.
CEC
Command: Power
- Press to send the CEC power on or off command out through the HDMI ports.
System Settings
Display Auto Power On
- Sets the unit to send the display power on command to the output, after the power on
delay amount, when signal is received.
Display Auto Power Off
- Sets the unit to send the display power off command to the output when signal is no
longer received for the set auto power off time.
Lamp cool down timer
- Sets the time between when the display is turned off and when the next command can
be sent.
Auto power off timer
- Sets the time between when the last signal was receieved and the display power off
command is sent.
Power on delay timer
- Sets the amount of time between when the display is turned on to when the unit sends
any commands.
Control Type
- Selects which command type is used to send commands and what type of control signal is sent
when the display button is pressed. Options are CEC, TCP/IP or RS-232.
Feedback Verify
- Enable (on) or disable (off) feedback verification to a control system or hyper terminal.
NOTE:
The Display page is only available when in mirrored or matrix switching w/static mode.