3
Mounting bracket x 2
The HDVS-150-TX comes with mounting brackets that can be used to affix the unit to a table,
desk, etc.
To affix the mounting brackets to the unit, use the four included screws. The bracket can be
affixed with the oval holes pointing to the bottom
(for against the wall - picture A)
or the oval holes
facing the top
(for under tables - picture B)
.
Larger oval
hole will be
attached to
the wall/table.
Mounting
Circular holes
will always be
attached to the
unit.
A
B
Set Up
RS-232 control is available when used with appropriate power supply and HDBaseT receiver
(AT-
UHD-CLSO-824)
with RS-232 capabilities.
The display on/off button can be used to transmit the following commands:
WP_Display[a]$
[a] ? , On , Off
Display On/Off control
To change inputs, the HDVS-TX should receive these commands:
WP_Input[a]$
[a] ? , Hdmi , Vga Select input source
The port settings for the control device are:
115200 bps, 8 bit data length, No parity bit, 1 bit stop-bit, No flow control
Note:
To set the port to 9600, press and hold the display on/off button
Note:
Each command is terminated with a carriage return
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
