6
www.atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Note:
Turning the unit’s Power (Off) over RS232 will distinguish the LED display leaving only the Power Switch LED on. While the
unit is turned off by RS232 it will continue to accept and act upon switching commands. For example, if the unit is in the off mode
(via RS232) and you send a command to switch an input to an output, that route will complete and the video and audio will now
appear on that channel only. The front panel LED for that particular output will also show the input selected (for that single output
channel only). The remaining LED’s will remain off and video and audio outputs muted. The unit will still return status and change
messages in response to commands sent while in Power (Off) state. A hard reset command (SBALLRST) will return the unit to nor-
mal operation and also unlock the front panel.
Power Off mode.
SBSYSMOF
- Put system into Standby (Soft Power Off)
SBSYSMON
- Bring unit out of Standby (Soft Power On)
Unit will respond with:
SBALOFAK
- Unit is in Standby
SBALONAK
- Unit is no longer in Standby
Example: Put Unit in Standby (Soft Power)
SBSYSMOF
- Send
SBALOFAK
- Rcvd
FRONT PANEL LOCK
Note: Hard resetting the unit will unlock the Front Panel controls.
SBSYSMLK
- When front panel is locked, changes can only be made by RS232
SBSYSMUK
- Front Panel Unlock
Unit will respond with:
SBSYSLOK
- Front Panel has been Locked
SBSYSULK
- Front Panel has been Unlocked
Example : Lock Front Panel Buttons
SBSYSMLK
- SendSBSYSLOK - Rcvd
UNIT RESET
SBALLRST
- Reset every output to Input 1
Unit will respond with:
SBRSTACK
- Unit has reset each Output to Input 1
Example: Reset all outputs to Input 1
SBALLRST
- Send
SBRSTACK
- Rcvd
RS-232 PROTOCOL COMMANDS
