AtlasSound.com
– 6 –
Specifications are subject to change without notice.
Owner’s Manual
PA1001G Power Amplifier
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
front Panel
1. Power switch
This switch turns the AC Mains power to the amplifier on or off.
2. Power led
Illuminates Red when the power switch is depressed. Red means the amplifier has AC mains power to the unit and
is standby or sleep mode. When LED is Blue the unit is active and will pass audio.
3. limit led
The Limit LED will illuminate Red if either channel of the PA1001G reaches maximum output power or if a fault is
detected with in the amplifier. The PA1001G features a true limiter circuit which help prevents the amplifier from hard
clipping or from being over driven. An occasional flash of the LED is ok, if the LED is on continuously reduce the
input level of the amp. After the reducing the input level and the Limit LED remains on, recheck the load connections
to the amp.
4. signal led
The Signal LED illuminates Green if there is audio signal present at the input of the amp.
5. input Gain
The Left and Right rotary control varies the amplitude of the signal fed into the amplifier. Turn clockwise to
increase and counterclockwise to decrease the signal level. Note: This post the RCA mix level control. See mix
function below.
6. Bass control
Normally set at the 12 o'clock position unity gain, rotating clockwise will increase (boost) bass frequencies to a
maximum of +6dB at 100Hz. Rotating counterclockwise from the 12 o'clock position will decrease (cut) bass
frequencies to a maximum of -6dB at 100Hz. Note: This feature affects both the Left and Right channels the same.
7. treble control
Normally set at the 12 o'clock position unity gain, rotating clockwise will increase (boost) treble frequencies to a
maximum of +6dB at 10kHz. Rotating counterclockwise from the 12 o'clock position will decrease (cut) treble
frequencies to a maximum of -6dB at 10kHz. Note: This feature affects both the Left and Right channels the same.
5
6
7
4
2
1
3