2
w
w
w
.
a
u
t
o
m
a
t
i
o
n
d
i
r
e
c
t
.
c
o
m
1
-
8
0
0
-
6
3
3
-
0
4
0
5
W
ARNING
: Damage can occur by applying excessive torque to the
mounting clips.
2. Install Monitor through Enclosure Door or Wall
• The monitor must be installed on a flat surface of a NEMA type 1, 4, 4X
or 12 enclosure.
• Use dimensions as shown in the diagram below to provide a
rectangular mounting cutout in an approved NEMA 4/12 enclosure’s
door or wall.
• Mount the monitor through the enclosure cutout, install and tighten (14)
mounting clips to a torque of 8.0 inch-pounds as shown in the diagram
to the right.
CUTOUT
A
B
Cutout Dimensions:
CUT AWAY
VIEW
MAXIMUM ALLOWABLE
PANEL THICKNESS
Mounting Clip Installation:
Warning: Suitable for use in Class 1, Division 2 Groups A, B, C,
and D; Class 2 Division 2 Groups F and G, Class III hazardous
locations, or nonhazardous locations only.
3. Connect DVI or VGA Video Cable between Monitor & PC
• Connect the included 10’ VGA video cable from the video connector on
the monitor to the video output connector on the host PC being used
with the monitor or use a digital DVI cable (sold separately).
• If using a DVI cable, input selection must be changed to DVI by pushing
the UP button on the rear of the monitor.
4. Connect USB or Serial Cable between Monitor & PC
• Applies to touch screen version only.
• Use either the included 10’ RS-232 Serial touch screen cable or the 10’
USB touch screen cable from the appropriate connector on the monitor
to the appropriate connector on the host computer; do not connect
both.
• If using the USB cable, secure the cable using the included USB
retention bracket and screw; consult the Hardware User’s Guide,
ATM-USER, on the supplied Documentation and Driver CD for details.
* NOTE: USE ONE OR THE
OTHER, NOT BOTH.
TOUCH SCREEN
CABLES *
VIDEO CABLE *
DISPLAY POWER
WARNING
Touch Screen is still
active while display
power is off
Cable Connections:
N
N
O
OT
TE
E
:: T
HE
17”
AND
19”
MONITORS WILL PRODUCE THE BEST IMAGE
QUALITY IF THE
PC
IS SET FOR A
1280
X
1024
PIXELS
@
EITHER
60,
OR
75 H
Z
.
VIDEO MODE
.
Model
A
B
ATM1500/ATM1500T
12.00”
(304.8 mm)
15.00”
(381.0 mm)
ATM1700/ATM1700T
13.70”
(348.0 mm)
16.35”
(415.3 mm)
ATM1900/ATM1900T
14.90”
(378.5 mm)
17.75”
(450.9 mm)
N
N
O
OT
TE
E
:: T
HE
15”
MONITOR WILL PRODUCE THE BEST IMAGE QUALITY IF
THE
PC
IS SET FOR A
1024
X
768
PIXELS
@
EITHER
60, 70
OR
75 H
Z
.
VIDEO MODE
.
N
N
O
OT
TE
E
:: W
HEN USING THE
USB
TOUCHSCREEN CONNECTION
,
THE USE
OF THE
USB
RETENTION BRACKET IS REQUIRED FOR HAZARDOUS LOCA
-
TIONS AND HIGHLY RECOMMENDED FOR NONHAZARDOUS LOCATIONS
.
W
ARNING
- E
XPLOSION
H
AZARD
- Do not connect or disconnect the
USB ports unless the power has been switched off or the area is
known to be non-hazardous.
A
VERTISSEMENT
- R
ISQUE D
'
EXPLOSION
- Ne pas brancher ou débrancher
le ports USB á moins que l'alimentation á été coupée ou si la zone
n'est pas hazardeuse.
A
DVERTENCIA
- P
ELIGRO DE EXPLOSIÓN
- No conecte o desconecte los
puertos USB a menos que la computadora se encuentre apagada o
el área se considere no peligrosa.
W
ARNUNG
- E
XPLOSIONSGEFAHR
- USB-Ports nur anschließen oder
trennen, wenn keine spannung anliegt oder der Bereich nicht
explosiongefährdet ist.
N
N
O
OT
TE
E
:: T
O
P
REVENT INADVERTANT DISCONNECTION OF VIDEO AND
/
OR
SERIAL TOUCHSCREEN CABLES ASSURE THAT THE THUMBSCREWS ARE
SUFFICIENTLY TIGHT
.
W
ARNING
: An operating temperature of 0 to 50 °C (32 to 122 °F)
ambient termperature inside the enclosure needs to be maintained
for proper operation of the monitor.
