4
PennEngineering • www.pemnet.com
OPERATING INSTRUCTIONS:
With the tool disconnected from the airline, check to see that the socket head cap
screw extends beyond the face of the anvil far enough to allow at least one thread
of the screw to extend beyond the end of the insert. If the screw is not long enough,
measure what is required and get a socket
head cap screw that is long enough.
If you set up on a first grip fastener and you
are going to install second grip inserts in
the same work area, get a screw that is long
enough to extend at least one thread beyond
the end of the longest fastener.
Now, connect the air line to the tool. Hold the threaded insert to the tool mandrel.
Actuate position ‘F’ of the trigger (figure 1) and start engagement of the insert threads
on to the tool mandrel. Stop fastener engagement just before the head of the insert
comes in contact with anvil face.
Insert the fastener into the installation hole of a test plate, that is the same material
and thickness, as the actual application.
Actuate the position ‘F’ of the trigger and let the socket head cap screw mandrel drive
through the fastener and clinch it securely into the test plate and allow the air tool to
stall.
Actuate position ‘R’ of the trigger (the bottom rocker) and disengage the tool mandrel
from the installed fastener.
GENERAL OPERATING INSTRUCTIONS
