10
Figure 20
Figure 18
Figure 19
ON ECE
1 2 3 4
A. I, II, III, IV, V and VI button:
These six buttons are used to set the fan speed as
follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
B. button:
This button turns the fan off.
C. Reverse button:
This button is to control fan direction
D.
Light button:
This button is to control light ON or OFF and also controls
the brightness setting.
E. SET code setting button:
Your DC brushless motor is equipped with automatically
learned type remote control and a wall control. If two
fans or more in a house, it is recommended that you not
use the factory code settings. Change codes setting to
any other combination of dip switch setting to avoid fan
interference issues. Please refer the "D" "SET" code
setting button section.
11. PROGRAMMING YOUR
FAN AND OPERATING
THE REMOTE CONTROL
AND WALL CONTROL
Before programming takes place, fan must be
fully assembled and mounted to the ceiling with
blades attached.
You must also choose which
control you will be using for programming the
fan, the remote or the wall control. No other wall
control should be used with this fan but that
whichwas included. Using another wall control
other than ours will damage your fan and void your
warranty.
Install one 23A/12V battery (included). To prevent
damage to transmitter, remove the battery if not used
for long periods of time (Fig. 18 & 19).
a) Select desired frequency from the transmitter.
Follow the below steps to set the remote control:
The auto learning function will only mandate within
60 seconds when turning the fan’s AC power ON.
b) From the wall or remote transmitter, Press and
hold “SET” button for about 5 seconds and release. If
optional light kit is installed, the signal light on the
wall control will come on when the button is pressed.
The fan has completed the pairing process with the
wall control and is ready for use.
