8
E. Fix the
Anchor
Bolts
1. Prepare
the
Anchor
Bolts
(See Fig. 13).
2. Using the prescribed rotary hammer drill, and drill all the anchor holes and install
the anchor bolts
(See Fig. 14).
F. Install the Safety Ladders
1. Take off the pulley safety cover and unscrew the four upper nuts of the Safety
Ladders, and then adjust the four lower nuts to be at the same position. Withdraw
the Slack-cable safety lock of the Cross-beam to insert the Safety Ladder in, raise
the Safety Ladder, and screw the upper nuts
(See Fig. 15).
Nut
Spring washer
Washer
Fig. 13
Fig. 14
Drilling
Tighten
Clearing
5
Fig. 15
Safety Ladder is inserted between
Limit Pins of the cross-beam
Slack-cable safety lock
Primary
safety lock
6
Limit Pin
Limit Pin
Safety Ladder
Safety Ladder is
inserted between
Limit Pins
Содержание 414A
