Atlas Copco XRHS 1150 CD4 C3 WUX, Инструкция по эксплуатации

Страница: 76 / 106

- 76 -
BATTERY CARE
If the battery is still dry, it must be activated as
described in section Activating a dry-charged
battery .
The battery must be in operation within 2 months
from being activated; if not, it needs to be recharged
first.
ELECTROLYTE
Electrolyte in batteries is a sulphuric acid solution in
distilled water.
The solution must be made up before being
introduced into the battery.
ACTIVATING A DRY-CHARGED BATTERY

Take out the battery.

Battery and electrolyte must be at equal
temperature above 10 °C (50 °F).

Remove cover and/or plug from each cell.

Fill each cell with electrolyte until the level
reaches the mark on the battery. If there is no mark
on the battery, the level must be above the plates
for at least 10 mm (0.4 in) to 15 mm (0.6 in).

Rock the battery a few times so that possible air
bubbles can escape; wait 10 minutes and check the
level in each cell once more; if required, add
electrolyte.

Refit plugs and/or cover.

Place the battery in the compressor.
RECHARGING A BATTERY
Before and after charging a battery, always check the
electrolyte level in each cell; if required, top up with
distilled water only. When charging batteries, each
cell must be open, i.e. plugs and/or cover removed.
Apply with preference the slow charging method and
adjust the charge current according to the following
rule of thumb:
Battery capacity in Ah divided by 20 gives safe
charging current in Amp.
BATTERY MAINTENANCE

Keep the battery clean and dry.

Keep the electrolyte level above the plates or at
the indicated level. Level above plates at least
10 mm (0.4 in) to 15 mm (0.6 in). Top up with
distilled water only.

Keep the terminals and clamps tight, clean, and
lightely covered with petroleum jelly.
COMPRESSOR ELEMENT OVERHAUL
When a compressor element is due for overhaul, it
needs to be done by Atlas Copco. This guarantees the
use of genuine parts and correct tools with care and
precision.
Before handling batteries, read the
relevant safety precautions and act
accordingly.
Read the safety instructions carefully.
Always pour the sulphuric acid carefully
into the distilled water; never pour the
water into the acid.
Use a commercial automatic battery
charger according to its manufacturer’s
instructions.