Atlas Copco Secoroc FT Series, Инструкция оператора и список запасных частей

Страница: 7 / 12

FT160A, FT160B, FT160C, FT170
7
Drilling
Starting the rock drill
1. Open the main valve for compressed air.
2. Open the cock for the flushing water.
3. Adjust the feed control lever to give a suitable feed force for collaring the hole.
4. Align the rock drill so that the working tool touches the desired collaring point.
5. Move the throttle lever forward a little, which will start water flushing,
percussion and rotation.
6. Collar the hole with reduced feed force.
7. Move the throttle lever fully forward once the working tool has gained a
secure footing in the rock.
8. Adjust the feed force by means of the control lever so that the maximum
penetration rate is obtained.
Stopping the rock drill
Pull the throttle lever backwards, which will stop percussion, rotation and flushing
water.
Re-positioning the pusher leg
1. Switch off the rock-drill percussion and flushing by means of the throttle lever.
2. Press the trigger, whereupon the piston rod is pulled back into the pusher-leg
cylinder automatically.
3. Re-position the pusher leg.
4. Release the trigger, whereupon the piston rod will move outwards again.
5. Move the throttle lever forward into the working position.
Note! The feed control lever does not need to be touched throughout this operation.