Atlas Copco AX28E, Инструкция по безопасности и эксплуатации

Страница: 13 / 25

A B C
Tightening torque, Nm Gluing Vibrating
head
AX28E
75 LOCTITE®
243™ End cap A
120 LOCTITE®
243™ Reducer B
- LOCTITE®
243™ Screw C
D E E G H F
Tightening torque, Nm Gluing Vibrating
head
AX65 AX56 AX48 AX40 AX36
750 520 350 170 170 LOCTITE®
638™ End cap D
20 8 8 5 5 - Screw E
250 250 200 120 120 LOCTITE®
243™
Reducer F
- - - - - LOCTITE®
243™
Thrust
screw G
- - - - - LOCTITE®
243™
Screw H
J I
Tightening torque, Nm Gluing Vibrating
head
AX90
1200 LOCTITE®
638™ End cap I
- LOCTITE®
243™
Screw J
LOCTITE®243™, LOCTITE®638™ are registered
trademarks of Henkel Corporation. 243, 638 are
trademarks of Henkel Corporation.
Disassemble the vibrating
head
1. Put the vibrating element in a tube vice and
clamp it.
2. Cut the clamp off the operating hose.
3. Pull the hose to remove it from the nipple.
4. Slide the rubber hose protection from the
terminals.
5. Cut the thermal insulation and disconnect the
terminals.
NOTICE Do not grease the inner shafts too
extensively. Greasing too much can cause overload
of the electric drive unit and trip the circuit breaker.
Run the unit for two minutes continuously to distribute
the grease in the flexible shaft before immersion in
the concrete.
Vibrating element AX28E
Disassembly
1. Unscrew the reducer (A) from the stator tube (B)
(left hand thread). The stator is glued inside the
tube.
2. Remove the complete tube (C) including the end
cap from the stator tube (B).
3. Remove the spring washer (D).
A D B C
4. Slide and remove the rotor (G), the excenter (E)
and the ball bearing (F).
C E F G
5. Unscrew the nut (H) (right hand thread), and
remove the rubber gasket (I).
6. Unscrew the nipple (J) (right hand thread).
H I J K
© 2013 Atlas Copco Construction Tools AB | No. 9800 1175 01b | 2013-04-29
Original instructions
12
AX 36, 40, 48, 56, 65, 90, 28E Safety and operating instructions