1. Dismantle the end cap (right hand thread) and
the tube connector (left hand thread).
2. Loosen the square screw cap on the drive side
by locking the eccentric. Use a screwdriver to
lock the eccentric, place the screwdriver into the
groove at the end with the end cap.
3. Locate the bearings and seals to be replaced.
Pull out the eccentric together with the two
bearings the vibrator tube. Pull out from the end
with the end cap.
4. Press the two bearings out of the tube.
5. Assemble in the opposite order.
Storage
♦
Clean the machine properly before storage, in
order to avoid hazardous substances. See section
“Dust and fume hazard”.
♦
Always store the machine in a dry place.
♦
Keep the machine in a safe place, out of the reach
of children and locked up.
Disposal
A used machine must be treated and disposed in
such way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible, and
in accordance with local restrictions.
Always send used filters and drained oil remnants
to environmentally correct disposal.
The electronic and electrical devices may contain
potentially hazardous substances. Do not dispose
of them in the nature. Dispose them according to
local laws and regulations for the country of use.
According to the European directives 2002/95/EC
and 2002/96/EC.
© 2015 Construction Tools PC AB | No. 9800 1191 01 | 2015-03-04
Original instructions
14
AME 600
Safety and operating instructions
