ENGLISH (EN)
WARNINGS:
This device is not intended for use by persons (including children) with physical,
sensory or mental disability, or by persons lacking experience or knowledge, unless they have
received from a person in charge of their safety adequate supervision or preliminary instructions
on how to use the device. Children should be supervised to ensure that they do not play with the
appliance. This unit can be used by children of not less than 8 years and people with reduced
physical, sensory or mental capabilities or without experience or knowledge if they are properly
supervised or if the instructions for using the device safely have been given and if the risks are
taking into account. Children must not play with the device. Cleaning and maintenance must not be
done by children without supervision.
1. CAUTION
!
Heavy item, handle with care:
1.1
Install the appliance in a room which is protected from frost. If the appliance is damaged
because the safety device has been blocked, it is not covered by guarantee,
1.2
Make sure that the wall on which the appliance is mounted can support the weight of the
appliance when filled with water,
1.3
If the appliance is to be fitted in a room or location where the ambient temperature is higher
than 35°C, provide sufficient ventilation,
1.4
When installed in a bathroom, do not install the appliance in volumes V0 and V1 (See fig.
❶
,
p.3). If the water heater is to install above living space, fit a retaining tank with drain to the
sewer system. Place the water heater in a place with easy access,
1.5
If PER pipes are used, the installation of a thermostatic regulator on the output pipe of the
device is strongly recommended. It will be set according to the performance of the material
used.
1.6
Installation of a vertical or horizontal wall mounted device: To allow the replacement of the
heating element leave a free space of 300mm between the tube ends and the wall or fixed
furniture.
1.7
Switch off the power before removing the cover, to avoid any risk of injury or electric shock.
1.8
The installation must be equipped, upstream of the appliance, with a bipolar cut-out device
(fuse, breaker switch) respecting local regulations (30 mA earth-leakage breaker).
1.9
If the supply cord is damaged, it must be replaced by a special cord or assembly available
from the manufacturer or the after sales service.
1.10
Mandatory installation of a safety device in a frost free location (or any other new device
which limits the tank pressure) to 7 or 9 bar (0.7 or 0.9 MPa) according to the nominal
pressure, with a size of ½ "or ¾" on the input of the water heater, respecting the local
regulations (see table p.1),
1.11
Operate regularly the discharge of safety device to prevent scaling and check that it is not
blocked.
1.12
Hydraulic accessories should not be located between the safety valve and the cold water
inlet. A pressure reducer (not supplied) is required when the water supply pressure exceeds
5 bar (0,5 MPa) and will be fitted on the main supply.
1.13
Connect the safety device to an unpressurised outlet pipe in a frost free location, with a
continuous slope to evacuate water during heating up or draining the water heater.
1.14
The pipes used must support 10 bars (1 MPa) and 100 ° C.
1.15
To drain the device: Switch off the power and the supply of cold water, open the hot water
faucets and manipulate the safety valve. To drain under sink water heater disconnect
the hydraulic connections and return the device.
1.16
Do not dispose your water heater in the garbage, but hand it to a place assigned for
this purpose (collection point) where it can be recycled.
INSTALLATION: See the general warnings 1 to 6
-
INSTALLATION OF A VERTICAL WALL-MOUNTED APPLIANCE: see fig.
❷
page 2).
-
Installation must done by qualified/approved personal.
