background image

To maintain performances of your unit, you should clean the upper and lower grilles of the unit about twice a year using a
vacuum cleaner or a brush.
Have a professional check the inside of the unit every five years.
Dirt may collect on the grille of the unit if the atmosphere is polluted.  This phenomenon is due to the poor quality of the
ambient air.  In this case, it is recommended to check that the room is well ventilated (ventilation, air inlet, etc.), and that
the air is clean.  The unit will not be replaced under the guarantee because of this type of dirt.
The unit casing should be cleaned with a damp cloth, never use abrasive products.

If the unit does not heat :

Check that the programmer is in COMFORT mode (electronical).
Make  sure  that  the  installation  circuit  breakers  are  switched  on,  or  that  the  load  shedder  (if  you  have  one)  has  not
switched off the unit power supply. Check the air temperature in the room.

The unit does not carry out programming orders : (version with pilot wire)

Make  sure  that  the  programming  unit  is  being  correctly  used  (refer  to  its  user’s  manual)  or  that  the  Chronocarte  is
properly inserted in its housing and that it is operating normally (batteries ?).

The unit is permanently heating :

Make sure that it is not in a draft and that the temperature setting has not been changed.
This unit with electronic control is equipped with a microprocessor that can be distribued by some severe mains voltage
disturbances (outside EC standards defining the disturbance protection level). If there are any problems (thermostat blocked,
etc.) switch off the unit power supply (fuse, circuit breaker, etc.) for about 5 minutes to allow the unit to start again.

Have your energy distributor check your power supply if the phenomenon occurs frequently.

MAINTENANCE

TROUBLE-SHOOTING

WARRANTY  CONDITIONS :

KEEP THIS DOCUMENT IN A SAFE PLACE

(This certificate should only be produced if you are making a complaint, attached with the invoice of the purchase)

- This guarantee is applicable for 2 years from the date of original purchase and shall be valid for no more than 30 months from the
date of manufacture.
- Your Atlantic distributor will exchange parts shown to be defective in manufacture. The replacement parts will be of charge but
Atlantic does not accept responsability for freight or labor charges or losses in transit.
- This guaranteeexcludes damage by neglect, shipping or accident and any damage due to incorrect installation, use or purposes
other than those intended or failure to observe the instructions given.

* This information is shown on the plate which can be seen on the left-side or behind the front grille of the unit.

INSTALLER’S  STAMP

UNIT TYPE *

:

SERIAL NUMBER *

:

CUSTOMER’S NAME AND ADRESS :

FOR SALES IN  NEW ZEALAND

ATLANTIC  AUSTRALASIA
Phone : 0800 422 000
Fax : 04 3800 509

FOR SALES IN AUSTRALIA

ATLANTIC  AUSTRALASIA  PTY  LTD

Free call : 1800 677 857

4/13-25  Church  Street

Phone : 03 9852 9599

Hawthom  Victoria  3122

Fax : 03 9852 9844

Australia

web  :  www.atlantics.com.au

FOR SALES IN THE U.K.,

 please contact :

ATOUR ATLANTIC LTD

Phone : 01580 2431 53

Malling  Works,  Lewes

Fax : 01580 2411 80

East Sussex BN7 2AY

E-mail  :  [email protected]

Содержание F17






Отзывы: