1 .3 .2 - Attaching the wall support to the wall
1
2
A
B
Sol
Place the wall support on
the floor. Mark the drilling
points A (cross) with a pen.
These provide the position
for the lower attachments.
Lift the wall support, lining
up the drilling points A with
the lower holes on the wall
support. Mark the 2 drilling
points B with a pen.
3
Drill the 4 holes and insert the plugs which are suitable for your
wall (e.g. plasterboard, concrete). Position the wall support
and screw in.
1 .3 .3 - Connecting the appliance
Take the appliance out of its cardboard box and remove the wedges.
To facilitate connection, this appliance has been designed to remain
upright during connection.
Connection rule
-The appliance must be supplied with 230V 50 Hz.
-The radiator's power supply must be connected directly to
the network after the single-pole disconnection mechanism, in
accordance with the installation rules. The radiator will be connected
to the mains with a 3-wire cable (Brown = Live, Blue = Neutral,
Black = Pilot wire) via a connection box.
-In damp rooms such as kitchens and bathrooms, the connection
box must be installed at least 25 cm from the ground. The installation
must be equipped with a 30mA differential circuit breaker-type
protection device.
DETAIL A
VOIR DETAIL A
A
Sol
