5
1
Solid Crystal White
2
Continuous full spectrum fade change
3
Solid Red
4
Solid Green
5
Solid Blue
6
Solid Aqua
7
Solid Purple
8
Solid Yellow
9
Red-Green-Blue jump change
10
7 color jump change
11
Red-Green-Blue dimmer change
12
7 color dimmer change
13
7 color dimmer then
7 color jump change
14
Flashing Red
15
Flashing Green
16
Flashing Blue
17
Flashing Red and Blue
Preset Light Changing Modes
Mode Selection
• To switch to the Color Wheel: hold the B button for three seconds or until the
light changes to Crystal White. Hold down the B button again, and the light will
return to the last color displayed while in the Color Wheel mode. Run your
finger around the color wheel to select a new color.
• To switch to the Preset Light Changing Modes: hold the B button for three
seconds or until the light changes to Crystal White. Hold down the B button
again, and the light will return to the last preset mode displayed while in the
Light Changing Modes. Press the D and E button to switch between the
different preset modes.
Changing the Brightness and Speed
In Modes 1-8 and 14-16, you can use the F and G keys to change the brightness
of the light. In Modes 9-13 and 17, you can use the F and G keys to change the
speed of the light transitions. There are 8 levels for each.
Synchronizing the Remote to the Control Unit
If the remote control stops working properly, please install fresh batteries. If
problems persist, the remote may need to be re-synced to the control module.
Follow the instructions below to re-sync the remote control.
1. Unplug the transformer
2. Hold the F button down (The red indicator lamp on the remote will be blinking)
3. While still holding the F button down, plug in the transformer. The Colorfalls
will start blinking.
