3
A
E
F
G
safety screws
B
C
2
1
This mount is designed to be attached into wood
studs.
DO NOT use wall anchors
. Using a stud
a pencil mark the hole locations at the desired
height, making sure you are level. Use the wall
plate (A) as a template to mark the two remaining
hole locations. Drill pilot holes at four pencil marks
2.5 in. (64 mm) deep, using a 7/32 in. or 5.5 mm
diameter drill bit.
Attach wall plate (A) to wall with four washers and
screws (E).
Attach TV mounts (B and C) to the TV back panel.
Make sure to select the same height screw holes,
so the mounts are centered and level.
Refer to the next page to select the correct
mounting hardware for your TV.
3
4
Turn two handles (F) into the mounts through
washers (G) but do tighten. After wall mounting
your TV, adjust TV to the desired viewing angle
and turn to tighten both handles.
We strongly recommend two people, one on
each side, hold the TV. Tilt the top of the TV
toward the wall. Carefully position TV mounts
(B and C) over the wall plate until both lock in
place. Tighten safety screws.
16in. /407mm
or
24in. /610mm
