10
FS-7.1 7-Channel Soundbar
Care of Your Speakers
Connecting Your System
We recommend that you connect your system using high quality dual
conductor stranded wire of 16 gauge or heavier, for lengths up to 25 feet
(8m) . Remember, the lower the gauge number, the heavier the wire. Use
heavier gauge wire for longer runs. Please contact your audio/video dealer
or installer for specific cable recommendations and further information
regarding special circumstances.
WARNING:
To prevent risk of electrical shock or damage to your
equipment, always switch off the amplifier or receiver when making
any system connections.
1.
Remove ½” (13mm) of insulation from each wire end.
2.
Twist the stranded wire together, keeping the two ends
separate.
3.
Place the appropriate wire through the postholes in the
connectors. These holes are revealed when you push down
on the post.
It’s important to observe polarity while making speaker connections: red
(+) terminals on the amplifier to red (+) on the speaker, black (–) on the
amplifier to black (–) on the speaker. Look carefully at the wires you are
using and note that one of the conductors of each pair will typically be iden-
tified by color, printing on the outer jacket, ridges on the outer jacket, or a
thread intertwined with the wire strands. By convention, the marked wire is
connected to the red (+) terminal. Whether you are connecting a complete
system, or adding a single speaker component to your present system, the
wiring should look like the system wiring diagrams on the opposite page
WARNING:
Before turning on the amplifier, be certain that no stray
wire strands are touching across any terminals as this might damage
your amplifier.
Finally, check the polarity of your speakers by listening to some stereo music
with good bass content. If the sound seems “hollow”, unusually spread out,
or seem to have weak bass, recheck your connections for proper polarity
and correct any out of phase connections by reversing the connections.
Care of Your Speaker
Clean your cabinet using a soft, lint-free cloth. If you wish, you can slightly
moisten the cloth with plain water. Do not use any other cleaning agents
or chemicals. Be careful not to get any water on the driver cones or tweeter
domes. After carefully removing the grilles from the speaker, gently clean
them with a very slightly damp, lint-free cloth.
To do so, use a fine awl or pick to gently pry the center grille forwards. Pro-
tect the cabinet's pry area with a piece of thin cardboard (like a matchbook
cover, etc.).
The screws which secure the end grilles will then be visible.
Avoid placing your speakers in direct sunlight or near a source of heat that
may, over time, damage the finish.
IMPORTANT: SAVE YOUR BOX!
If you can do so, save the carton,
packing pieces, and plastic bags that came with your speaker. They
will be useful in case you move or have to ship your loudspeaker for
any reason. In any case, save all packing materials until you are certain
that the system has suffered no damage in shipment. If you find such
damage, either visible or internal, contact your dealer immediately.