Atlantic Technology 3.1 HSB, Инструкция по эксплуатации

Страница: 10 / 12

3.1 HSB Speaker Base System with H-PAS
10
Specifi cations
Specifi cations
Front Channels
Woofers (6) Heavy-duty 3 1/2" (115mm) composite paper cone
Tweeters (3) 3/4" (19mm) soft dome, Ferrofl uid cooled
Frequency Response 125Hz-20kHz
Nominal Impedance 6 Ohms per channel
Crossover frequency 3.75kHz, 2nd order
Sensitivity 89dB
Recommended
Amplifi er Power 10 - 150 Watts RMS per channel
Magnetic Shielding No
Powered Subwoofer
Subwoofer Down fi ring 6 1/2" (165mm) long-throw composite paper cone
Amplifi er Power Internal; 80 Watts RMS <.2% distortion
Frequency Response 35 Hz - 220 Hz
Peak Output 106dB SPL
Input (1) RCA line level
Power Requirements 110-240V, 50/60Hz 2.5A (24VDC 4A Power Supply included)
Speci fi ca ons are those in e ff ect at the me of prin ng. Atlan c Technology Interna onal, Corp. reserves the right to change
speci fi ca ons or designs at any me without no ce and without obliga on to modify exis ng units.
IMPORTANT NOTE:
The power recommenda on for this speaker assumes that you will not operate your ampli fi er/receiver in a way that produces
distor on. Even rugged speakers like ours can be damaged by an ampli fi er driven into audible distor on. The harsh ampli fi er
distor on (“clipping”) that occurs in this situa on will eventually cause damage to the speaker system. This type of damage may
be cumula ve and can build up over me, as the ampli
fi er is driven into overload again and again. Such damage is easily iden fi -
able through examina on of the damaged speaker’s voice coil and is not covered by the warranty
Dimensions
(WxHxD) 35 3/4" x 4 3/4" x 16 3/4" (including grille)
910mm x 120mm x 426mm
Weight 29 lbs.
System