Atlanta Attachment Company 3200PB1, Техническое руководство и перечень запасных частей

Страница: 22 / 48

Technical Manual & Parts Lists
17
Motor Parameter Settings
(3300A FeedPAR)
Before Programming, Perform a Master Reset of Parameters (See Below)
PARAMETER RANGE VALUE DESCRIPTION
290 0 Mode of operation. MUST SET THIS PARAMETER FIRST!
110 70-390 70 Positioning speed = 700 rpm
111 0-999 120 Maximum speed = 1200 rpm.
119 1-3 1 Linear acceleration
153 0-50 35 Braking power at standstill
161 0-1 1-CCW Motor rotation
207 1-55 35 Braking
220 1-55 1 Acceleration
240 0-56 55 Enable reverse run of motor with input 1
270 0-5 5 No handwheel sensor
272 020-255 100
Drive ratio between motor pulley and handwheel pulley. If handwheel
pulley is smaller than motor pulley, increase this value to slow down
sewing head until measured speed matches speed set with
parameter 111.
436 0
Use code "5913". This disables an input that was causing box to
reset itself.
401 0-1 1 Immediate save all parameters before turning off power
Front panel LED's: Programming Instructions:
LED 1: Off 1. Power on holding down the "P" button till "COD" is displayed.
LED 2: Off 2. Press ">>" once and enter the number "311"
LED 3: Off 3. Press "E" once and "2.0.0." is displayed this is a parameter
LED 4: Off 4. Proceed to the parameter to be changed and press "E"
LED 5: Off 5. The value now shows in the screen, adjust to desired value.
LED 6: Off 6. Press "E" to enter value and continue with parameter setting.
LED 7: Off, Stop at needle down. 7. Repeat for other parameters, press "P" once when complete.
LED 8: Off 8. Run sewing head to save parameters before powering down
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "591"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default values.
Speed RPM Treadle/Low
Fast 151 C
Slow 28 B&C