Atlanta Attachment Company 1347D, Техническое руководство и перечень запасных частей

Страница: 16 / 64

Technical Manual & Parts Lists
11
Operating Procedure
1. Press the green button on the circuit breaker on the back of the control box. Leave this on
except when locking out the power for maintenance.
2. Press the On/Start button momentarily to power up the machine. The amber Sensor light
should light.
Note: Pressing the On/Start button a second time will run the machine at high speed.
3. Press the Stop button at any time to stop the machine.
Note: The Emergency Stop button will disconnect power to the machine
4. Turn on or off the Left and Right sewing heads as required.
5. Set the rewind direction as desired.
6. Load the required binding into the binders.
7. Load the material roll onto the front roll holder.
8. Adjust the sewing heads and folders for desired finish width. Most adjustments are made
moving only the left head.
9. Adjust the front guide and roll holder to the folders.
10. Feed the material from the roll, between the front guide rods, and into the folders.
11. Raise the presser feet and puller roller by activating the switch on the front of the control
panel.
12. Pull the material through the folders, past the binders, and through the puller roller with
about 1 foot extending beyond the puller guard.
13. Close the puller roller and lower the presser feet.
14. Run the machine with the manual sew pedals until enough material is fed out of the puller to
wrap around the rewinder spindle.
15. The material must go under the first guide rod (behind the puller) and over the second guide
rod.
16. Adjust the rear guide rods and clutch air pressure for desired rewind roll tension.
17. Wrap the material around the rewinder spindle, being sure it is caught by the drive rod on the
spindle.
18. Press the On/Start button to run the machine at full speed in automatic mode. You must hold
the button on until the Sensor light goes out (approx. 2 seconds).
19. Use the Stop button to stop the machine.
20. Use the Emergency Stop button to turn off power at the end of the shift.
21. If the Sensor light does not go out, check for thread breaks and uncovered material/ binding
sensors.
22. When the front material roll gets low a sensor will stop the machine for splicing on the next
roll. Overlap the rolls about 2" with the new roll under the current roll and staple together.
Operate the machine with the manual sew pedals until the splice is past the puller. Cut the rolls
apart and reload the rewinder.
From
the
library
of:
Diamond
Needle
Corp