Manual, Collision Sensor,SR‑82
Document #9610‑60‑1007‑08
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati‑ia.com
16
5.1.3 Cover Plate and Stem Re‑assembly
1.
Apply a generous coating of CRC Extreme Pressure Moly C.V. Joint Grease (Moly Grease) to
the top surface of the piston (refer to
2. Apply a generous coat of moly grease to each of the (3) ball segments on the stem assembly and
to the rounded edge of the shoulders between the ball segments. Apply a layer of moly grease to
the flat underneath surface of the stem (refer to
).
3. Apply a generous coat of moly grease to each of the (3) v‑grooves in the cam and to the
rounded edge of the clearance ring (refer to
).
4. [This step applies only to SR‑82s with the Boot option.] Apply Loctite 515 Gasket Eliminator to
the top surface of the body.
5. With the stem assembly upright, set the cover plate assembly onto it. Make certain that the
alignment grooves are lined up (refer to
).
6. Place the stem and cover plate together onto the body. Make certain that the alignment grooves
in the plate and the stem are still lined up (refer to
).
7.
Press the cover plate down onto the body.
8. Apply Loctite
®
222MS to the (4) socket head cap screws and thread them into the body. Tighten
the screws to 25 in‑lbs (2.8 Nm).
Figure 5.5—Cover Plate and Stem Alignment
