Manual, F/T Sensor, Data Acquisition (DAQ) Systems
Document #9620-05-DAQ.indd-20
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •
• Email:
15
2.9 Power Supply Box
The Power Supply (PS) box is used with larger transducers that have on-board interface electronics. To
connect to the transducer, the PS is equipped with a 20-Pin female connector for the transducer cable
connection. A 12 V wall-mounted power supply is included with the PS box. The PS box can be powered
using the power supply cable from the DAQ device. A 26-pin male connector provides the interface to the
DAQ Device.
Power to the PS box can be provided through either the 12 V wall-mounted power supply included with
the PS box; or a 5 V source to the 26-Pin male connector located on the box. The PS box only requires
one source; if both sources are connected, the PS box will use the 12 V source and the 5 V source will be
ignored.
Figure 2.9—Power Supply
20-pin Female
Transducer Connector
Power Supply
Box (9105-PS-1)
26-pin Male
DAQ Device Connector
12 V Wall Mount Power Supply, 2 A, 24 W
(9105-PS-KTPS24-12020MP)
2.10 Power Supply Cable
The power supply cable connects the Power Supply box or Interface Power Supply box to the DAQ
Device or DAQ card. This cable usually has a connector on the data acquisition end but is also available
unterminated.
Figure 2.10—Power Supply Cables
26-pin Female Connector
to Power Supply or
Interface Power Supply
Connection
to DAQ Device
Unterminated
Connection
to DAQ Device
