Ather 450X, Быстрый старт

Страница: 51 / 62

The charger speaks to you. The changing state of the
LED light communicates to you about how it’s doing.
Every colour tells you something:
Solid amber light - Charger software is being
updated over-the-air (OTA)
Solid green light
When not connected to the scooter - Charger is
healthy and is available for charging
When connected to the scooter -Charging is done
Blinking green light - Charging in progress
Solid red light - Fault in the charger. Please contact
customer support
No light - No power
WHAT DOES THE LED SAY?
Using the Ather Charging
Cable
Plug in the 3 pin connector of the charging cable
into the 5A socket. Plug in the other end of the
cable to the scooter’s charging port. Turn the
key to OFF position & pull out the scooter key.
To plug out, keep the key in the ON position, wait
for 5 seconds, then remove the charging
connector and close the charging port flap.
Remove the key once your scooter is
connected to charger/disconnected
from the charging cable.
Do not turn the key ON and pull out the
connector, at the same time. Hold on for
5 seconds to pull the connector out.
Do not attempt to remove the connector
while your scooter is charging, you run the
risk of damaging the connector or the
scooter.
CAUTION
40
Note: If you don’t see any
light (when there is power
in your premises), press
Reset Button on PRCD
(Portable residual-current
device). If the charger still
remains non-functional,
contact customer support.