1.
Set up a standard metal wire rack with the proper LED clone lights and connections.
Note:
Use LED clone lights only. Not compatible with heat-emitting lights such as T5 fl uorescent.
2.
Ensure the shelving is 70 inches tall, 48 inches wide, and 18 inches in depth.
Note:
The height measurement is taken from the lower end of the bottom shelf to the top end of
the top shelf (
FIG A
).
3.
Place the base panel onto the top of the bottom shelf (
FIG B
).
Note:
The magnetic strip on the base panel indicates where the front doors will be facing.
Warning:
Do not bend the magnetic strips.
4.
Wrap all four sides of the base panel over the edge of the wire shelf and connect them to the
bottom side of the base panel itself using the velcro strips (
FIG C
).
Note:
Press the velcro strips together fi rmly to ensure a seal through the gaps in the metal wire
shelving
(FIG D)
.
5.
Unfold the cover and open the magnetic strip doors.
6.
Wrap the right side over the top of the rack, setting it fi rmly onto the two right corners (
FIG E
).
7.
Follow over to the other side wrapping the cover completely over the rack (
FIG F
).
8.
Seal the bottom of the
VPDome™
cover to the base panel using the velcro strips along the sides
and back (
FIG G
).
Cleaning Instructions:
The
VPDome™
should be cleaned between every cycle of clones to prevent pest and pathogen
growth. Use a solution of Athena Reset at 1 oz per gallon of water to spray all sides of the
VPDome™
.
Scrub all treated sides with a cleaning pad and allow to dry.
E
F
G
70”
A
B
C
D
1. Installation Instructions
Athena
®
VPDome
™
