Chapter 2. Hardware Setup
6
Rear View
No.
Component
Description
1
Cable Tie Slot
If you are using a cable tie to gather the cables together,
run it through this slot to attach it to the unit.
2
Power Jack
The power adapter cable plugs in here.
3
Firmware Upgrade
button
Press this to have the VS0108HB enter Firmware
Upgrade Mode. When the upgrade is done, press it again
to exit the mode.
4
HDMI Output Port
section
The cables from your HDMI display devices plug into
these ports.
5
EDID Mode Switch
Turn this switch to select the EDID mode (0~7). See
“EDID Mode Selection” on page 10.
6
HDMI Input Port
The cable from your HDMI source device plugs in here.
7
RS-232 Serial Port
This is the serial remote port for output source selection
and high-end system control, as well as for upgrading the
device firmware.
1 2
3
4
5
6
7
