- 7 -
Hardware Installation
Before you Begin
Single Stage
Setting up the Video Matrix Switch is simply a matter of plugging
in the cables. Refer to the installation diagram on the next page
(the numbers in the diagram correspond to the numbered steps)
and do the following:
1. Use a high density HDB-15 male/female VGA cable to con-
nect the computer’s video port to any available video input
port on the Video Matrix Switch.
2. Use a male/male audio cable to connect the computer’s
speaker port to the audio input port that corresponds to the
video input port you connected in step 1.
3. Connect the monitor to any available video output port on the
Video Matrix Switch.
4. Connect the speakers to the audio output port that
corresponds to the video output port you connected in step 3.
Note:
Repeat steps 1 - 4 for any other ports you wish to set
up.
5. Plug the power adapter that came with the Video Matrix
Switch into an AC power source, then plug the power
adapter cable into the switch’s Power Jack.
6. Power on the attached equipment.
1. Make sure that the power to all the devices you will
be connecting up has been turned off.
2. Make sure that all devices you will be connecting
up are properly grounded.
VS-0202_0204_manual.fm Page 7 Friday, March 3, 2006 3:51 PM
