
- 8 -
Hardware Installation
Before you Begin
Single Stage
Setting up the Video Splitter is simply a matter of plugging in the
cables. Refer to the installation diagram on the next page (the
numbers in the diagram correspond to the numbered steps) and
do the following:
1. Use a high density HDB-15 male/female VGA cable to con-
nect the computer’s video port to the video input port on the
VS-0116.
2. Use a male/male audio cable to connect the computer’s
speaker port to the audio input port on the VS-0116.
3. Connect a monitor to any available video output port on the
VS-0116.
4. Connect speakers to the audio output port that corresponds
to the video output port you connected in step 3.
Note:
Repeat steps 3 and 4 for any additional monitor(s) and
speakers that you wish to connect.
5. Plug the power adapter that came with the VS-0116 into an
AC power source, then plug the power adapter cable into the
splitter’s Power Jack.
6. Power on the attached equipment.
1. Make sure that the power to all the devices you will
be connecting up has been turned off.
2. Make sure that all devices you will be connecting
up are properly grounded.
Содержание VS-0116
Страница 9: ...9 Single Stage Installation Diagram 1 2 5 3 4...
Страница 11: ...11 Cascaded Installation Diagram 1 2 4 5 3...